Official PPG Sigma distribution • Poland and Europe+48 533 220 562 · handlowy@marfarb.pl

Technical guide

How to prepare steel before painting

Even the best paint cannot provide durable protection on poorly prepared steel. System adhesion depends on cleanliness, roughness profile, salt removal and conditions during application.

1. Assess the surface

First establish the steel's condition: rust, mill scale, old coating, oil, salts and other contamination. Welds, sharp edges, weld spatter and hard-to-reach areas must also be inspected.

2. Degrease and wash

Grease and oil should be removed before mechanical preparation or abrasive blasting to avoid spreading contamination across the surface. Washing off soluble salts may also be important in a marine environment.

3. Remove rust and create a profile

For many industrial systems, abrasive blasting to the grade specified in the data sheet is preferred, often assessed under ISO 8501-1. This provides cleanliness and an anchoring profile. Mechanical preparation is sometimes used for refurbishment, but only where permitted by the selected product.

  • round sharp edges
  • remove spatter and weld defects
  • remove dust after preparation
  • check cleanliness and profile

4. Application conditions

Before coating, check steel and air temperature, humidity and dew point. The surface must meet the requirements of the specific product data sheet. Do not delay after preparation, to prevent renewed rusting or contamination.

Need a specific system?

Describe your project and exposure conditions.

We will help select PPG Sigma products and estimate the required quantity.

Send an enquiry